Pro Tools, Please Help. |
|
Pro Tools, Please Help. |
|
|
|
|
May 25 2007, 07:45 PM |
I use Pro Tools LE 6.8.1 for recording. I just recorded a song with bass guitar, electric guitar and drums, and everything sounds good, but the problem is that when I render it/"bounce to disk" the track gets waaaaaaaaay too much bass. So my question is, how do I control the bass and treble in pro tools? Or any other way to do it. Thanks. I don;t use pro tools specifically., but here are some generic suggestions ... First, Make sure your monitoring environment is set up well with no bass dips or spikes. If there are dips it would force you to mix the bass up to sound ok in your mixing environment which would then sound too bassy everywhere else If your question is more about how to cut out the bass, you could try: 1. Reducing the level of the bass tracks 2. Using EQ to cut out the deeper bass 3. Use EQ to cut bass out of instruments ither than the bass guitar - too much in one frequency space will make things sound very muddy 4. Use some compression to smooth out your bass levels to make it easier to mix. This post has been edited by Andrew Cockburn: May 25 2007, 07:45 PM -------------------- Check out my Instructor profile
Live long and prosper ... My Stuff: Electric Guitars : Ibanez Jem7v, Line6 Variax 700, Fender Plus Strat with 57/62 Pickups, Line6 Variax 705 Bass Acoustic Guitars : Taylor 816ce, Martin D-15, Line6 Variax Acoustic 300 Nylon Effects : Line6 Helix, Keeley Modded Boss DS1, Keeley Modded Boss BD2, Keeley 4 knob compressor, Keeley OxBlood Amps : Epiphone Valve Jnr & Head, Cockburn A.C.1, Cockburn A.C.2, Blackstar Club 50 Head & 4x12 Cab |
|
|
||
|
|
|
May 25 2007, 09:03 PM
|
|
Just a question from my end... did the bass first sound boomy after bouncing and not before?
|
|
||
|
|
|
May 26 2007, 12:58 AM |
Just a question from my end... did the bass first sound boomy after bouncing and not before? The bass was just a big soup after bouncing, not that bad before. |
|
|
||