Lead Sound |
|
Lead Sound |
|
|
|
|
Jun 23 2008, 09:19 PM |
Maybe post it here and get our opinions? I'll check back
This post has been edited by Henry Dietzel: Jun 23 2008, 09:19 PM -------------------- |
|
|
||
|
|
|
Jun 23 2008, 09:27 PM |
Ok here's the line6 POD patch
|
|
|
||
|
|
|
Jun 23 2008, 09:28 PM |
Imo a lead tone should have plenty of mids. If you forget about the BT and just play along to a mp3 and find what cuts and what doesn't.
Then I'm not sure, if there's a quality loss somewhere on it's way to the computer... what's your soundcard and what do you use to record your guitar? -------------------- My bands homepage
All time favourites: B. Streisand - Woman in Love, M. Hopkin - Those were the days, L. Richie - Hello |
|
|
||
|
|
|
Jun 24 2008, 12:18 AM |
This is because modelling software uses wider areas of the spectrum to make the signal look alike the real amp, and generally this is not good. Also the sound of the guitar will not sound the same soloed and in the mix. Often certain frequencies gets phased out and lost in the mix. Look at it this way - if a bass guitar are stronger than guitar signal at say 100Hz, even by an notch of dB, you will most likely loose perception of guitars low end in behalf of bass.
This is a very simplified example, in reality things are much complex. What you wanna make sure is to give the guitar a lot of mids, thus using a space in the spectrum where you can actually hear it properly in the mix. Don't worry if it sounds horrible, don't be afraid to experiment, sometimes the weirdest settings can lead you to phenomenal results later in the mix. In time you gain experience to recognize and anticipate the signal features. -------------------- - Ivan's Video Chat Lesson Notes HERE
- Check out my GMC Profile and Lessons - (Please subscribe to my) YouTube Official Channel - Let's be connected through ! Facebook! :) |
|
|
||
|
|
|
Jun 24 2008, 12:20 PM |
You can do a series of simple mixing exercises like this:
- Load any backing, and play over it. - run a spectrum analyzer check and see where are the peaks on guitar track - with EQ scoop the backing in the place where the peaks were on the guitar track - surf the scooped spectrum area to fine tune the backing. - EQ the backing additionaly where there are littel peaks on guitar track - level up tracks you can repeat this many times, every time you repeat it you get the feeling for it. -------------------- - Ivan's Video Chat Lesson Notes HERE
- Check out my GMC Profile and Lessons - (Please subscribe to my) YouTube Official Channel - Let's be connected through ! Facebook! :) |
|
|
||
|
|
|
Jun 25 2008, 11:15 AM |
EQing is and art and it requiers a lot of practice, try it and you will see what I'm talking about.
-------------------- - Ivan's Video Chat Lesson Notes HERE
- Check out my GMC Profile and Lessons - (Please subscribe to my) YouTube Official Channel - Let's be connected through ! Facebook! :) |
|
|
||