Pod X3 Dry Signal Options

[crazytrain101]

I just downloaded pod farm and saw that the pod x3 should be able to record a wet and dry signal at the same time. I am using sonar home studio six. When i go to choose the input through the pod x3 i only get the choices for left,right, and stereo. Other people say to choose ASIO inputs but i can't seem to get those to show up. Any help is appreciated.

You are at GuitarMasterClass.net

Don't miss today's free lick. Plus all our lessons are packed with free content!

Don't miss today's free blues, jazz & country licks. Plus all our lessons are packed with free content!

[Ivan Milenkovic]

FROM THE MANUAL:

Recording Tone 1 & 2 to Separate Mono Tracks
1. Connect outputs to your recorder:
• POD X3: connect the 1/4-inch outs.
• POD X3 Live & POD X3 Pro: the XLR outputs are recommended for live sound
systems, to provide a level that approximately matches a mic’ed up amp. You can
also use them for recording into mic preamps, or use the 1/4-inch outputs to get
hotter, line level outputs.
2. Set the second OUTPUTS page (Studio/Direct Mix):
• Tone 1: On
• Tone 1 Pan: pan left
• Tone 2: On
• Tone 2 Pan: pan right
3. When using the 1/4-inch jacks, also set the first OUTPUTS page (1/4-inch):
• Mode: MATCH STUDIO/DIRECT
4. In your recording system, assign those outputs to separate recording tracks.


Hope it helps mate. In Sonar you should make 2 separate mono audio tracks and choose the source like this:

TRACK 1 - LEFT
TRACK 2 - RIGHT

You are at GuitarMasterClass.net

Don't miss today's free lick. Plus all our lessons are packed with free content!

Don't miss today's free blues, jazz & country licks. Plus all our lessons are packed with free content!