Discussion On Modelling |
|
Discussion On Modelling |
|
|
|
|
Apr 12 2019, 06:46 PM | ||
|
||
|
|
|
Apr 15 2019, 04:31 PM |
What I've noticed specifically with recording is that if all the tracks have been done "in the box", that my real amp'd guitar tone seems to not fit the vibe most of the time. My general impression is that it's just too live or too spacious (if that makes any sense). A lot of engineers and producers and the artists initially would like to have a big or live, analog 'rock' (ish) guitar sound on their tracks. You know, use all those cool mics they have plugged into the high-end pre amps and comps. Gotta justify the expensive gear, right?
I always suggest that they also take a DI'd clean signal so that they can re-amp and/or model as needed later - just as a safety . 75% of the time, the DI'd track ends up being the one used. Amp tones that do tend to work or fit into these types of mixes are usually cleaner parts - small amp, close mic'd in a small dead room with one SM57. This post has been edited by klasaine: Apr 16 2019, 02:52 AM -------------------- - Ken Lasaine
https://soundcloud.com/klasaine2/foolin-the-clouds https://soundcloud.com/klasaine2/surfin-at-the-country-hop Soundcloud assorted ... https://soundcloud.com/klasaine3 New record ... http://www.cdbaby.com/cd/kenlasaine Solo Guitar ... https://www.youtube.com/playlist?list=PLXZh...5iIdO2tpgtj25Ke Stuff I'm on ... https://www.youtube.com/playlist?list=PLXZh...b-dhb-4B0KgRY-d |
|
|
||
|
|
|
Apr 18 2019, 08:34 PM |
... Thats interesting cause TH-U's respire tech. is simply saturation after the cab. |
|
|
||
|
|
|
Apr 19 2019, 06:58 PM |
Sampling rate of 2f is sufficient to represent the signal of frequency f. See sampling theorem if you want the math.
Unless you go with some low sampling rate (below 44.1 kHz), you should be able to capture everything within human hearing range. The dowside of sampling is the very upper overtones can't be accurately captured by any machine due to the units self-noise. These overtones get very low on level and blends too much with the noise character so usually filtered out. But most are accurate and there may be an AI that guess and replicates the missing ones for a more natural feel. |
|
|
||
|
|
|
Apr 19 2019, 09:37 PM |
Sampling rate of 2f is sufficient to represent the signal of frequency f. See sampling theorem if you want the math. Unless you go with some low sampling rate (below 44.1 kHz), you should be able to capture everything within human hearing range. Hey madfish, I was referring to sat./dist. sampling which is a very different matter. |
|
|
||
|
|
|
Apr 19 2019, 11:37 PM |
... What do you think about what respire adds/helps guitars in the mix? I demo's at the time but don't have it now. |
|
|
||
|
|
|
Apr 22 2019, 06:26 PM |
Pretty much what kemper is doing but my experience is based on this plug-in more (though haven't been using it in a long while) https://www.acustica-audio.com/store/t/nebula , aside ir also it can replicate drive character.
|
|
|
||