Routing Of Effects
Routing Of Effects
Jun 25 2009, 08:43 AM
Learning Tone Master
Joined: 18-June 09
From: Genarp, Sweden
Member No.: 7.291
I'm trying to build a pedalboard of pro-quality with the following effects:
Sansamp (for distorsion)
Boss OD-20, distorsion
Ernie Ball volume pedal
BOSS DD-2, delay
and eventually a BOSS digital reverb.
This would be routed with an A/B switch to either my Fender Amp or Marshall.
I also have a TC G-major (which I found out steals the tone from the guitar, when putting it before the preamps)
I guess I have to put it in a effect-loop after the preamp.
The major question here is in which order the effects should be connected.
Right now I use them before the preamp since the Marshall doesn't have an effect loop.
Any suggestions guys?
Guitars: Ibanez AM-200, Ibanez GB-10, Fender Stratocaster Classic Player, Warmouth Custom Built, Suhr Classic Strat, Gibson Les Paul Standard 2003, Ibanez steel-string
Amps: Fender Hot Rod Deluxe, Marshall JMP 2103, AER 60
Effects: BOSS DD-20, Danelectro Trans. Overdrive, TC-Electronics G-Major, Dunlop Wah-wah, Original SansAmp, BOSS DD-2
Music by Staffy can be found at: Staffay at MySpace
Jun 25 2009, 12:12 PM
Group: GMC Instructor
Joined: 22-June 07
Member No.: 2.159
Volume pedal should go first IF you wanna work on different guitar output,
if you wanna adjust overall level that goes to amp
then you should put it at the end of chain tho.
Then goes Wah, dists and ODs, delay and reverb.
Ofc delay and reverb would work best if you put them in loop,
same goes for G Major you mentioned
since that kind of effects is usually applied after preamp section.
That would be most common routing but you can experiment
a little as well to get more from your setup,
there are some "rules" for routing but your ear is the judge here.
|Lo-Fi Version||Time is now: 25th January 2017 - 02:36 AM|