3 Ways To Treat Di Guitars
Todd Simpson
Jan 1 2022, 11:44 AM
GMC:er
Posts: 25.297
Joined: 23-December 09
From: Atlanta, Georgia, USA
These days, we use a LOT of DI guitar tracks. We feed those tracks to virtual amps and in some cases we feed them to real amps and do actual “re amping” with an actual amp. Of course, we can re amp with virtual amp as well, using the same DI. Let’s talk about how to treat a DI. This could be your own guitar, or a guitar track you were sent to integrate into a project that you are working on.

The pitfalls for working with a DI track are many. After all, your amp, be it virtual or actual, will only sound as good as the signal that you feed it. There are a variety of things that can get in the way of a good signal. Anything from weak pickups, to dead strings, bad DI box, etc. can result in a less than ideal direct signal being recorded. If this is the case then your work is cut out for you. Whether you recorded this yourself or were sent it, doesn’t really matter. The same problems are there either way. If you have a bad DI signal, you can spend way longer than is needed trying to tweak it to properly feed the amp, virtual or otherwise, that you are trying to feed in order to get good results and serve the mix and the song. So what can be done?

Well, firstly you can try to E.Q. the DI. Before the signal is fed to an amp or a sim, you can pass it through a parametric E.Q. and try to get the level and frequencies up to snuff. You can start by filtering out unwanted low end frequencies below about 80hz. This will come down to your own ear of course, but lower frequencies can overwhelm any high gain amp and result in a very boomy sound that is just not tight enough. It’s better to try to trim the lower frequencies before they get anywhere near your amp/sim.

Next up, trim the mud. There is often a bit of muddyness around 200hz or so. Take your parametric E.Q. and pull back that area with a soft bell curve. This will allow the tone to remain tight and pull out the muddy vibe that can easily wreck a mix. Next up, use your ear and find a good spot to boost the high frequencies in your parametric E.Q. to add clarity. At this point your Sim/Amp should be in the loop so you can hear the results.

Next up, add a compressor after the E.Q. This is a great way to catch peaks and adjust the compressor until the signal is nice and smooth. Try a fast attack and a slow release so that the overall volume doesn’t jump around too much. Now try to boost the makeup gain on the compressor so as not to starve the amp/sim from having enough signal. So we have now shaped and boosted our singal, all in software.

You can also get creative and duplicate the DI track and use an octave plugin to create a lower octave version of the same track. You can then adjust the EQ for this track as it can be much deeper. Adding this octave lower track can add real depth to your tone. Boost the output volume a bit on the octave track and blend it with the original track and BAM. Chugg for dayz.

*This video was very helpful in creating this article.








You are at GuitarMasterClass.net


Don't miss today's free lick. Plus all our lessons are packed with free content!

Don't miss today's free blues, jazz & country licks. Plus all our lessons are packed with free content!
Go to the top of the page
 
+Quote Post
Phil66
Jan 1 2022, 08:32 PM
Learning Apprentice Player
Posts: 10.149
Joined: 5-July 14
From: The Black Country, England
Very interesting, thanks for sharing. I think he could have used a better track for the demo in the video though, it sounds weird to me, like someone is slowing down the turntable intermittently.

This could be helpful for some too https://www.gearnews.com/improve-your-produ...s-and-channels/

Cheers

You are at GuitarMasterClass.net


Don't miss today's free lick. Plus all our lessons are packed with free content!

Don't miss today's free blues, jazz & country licks. Plus all our lessons are packed with free content!


This post has been edited by Phil66: Jan 1 2022, 08:39 PM


--------------------


SEE MY GMC CERTIFICATE





Success is not obtained overnight. It comes in instalments; you get a little bit today, a little bit tomorrow until the whole package is given out. The day you procrastinate, you lose that day's success.

Israelmore Ayivor
Go to the top of the page
 
+Quote Post
Todd Simpson
Jan 2 2022, 05:47 AM
GMC:er
Posts: 25.297
Joined: 23-December 09
From: Atlanta, Georgia, USA
Indeed it does smile.gif Thats a very trendy djent thing doing a reverse bend. Starting with a note bent up a bit and striking it then letting it fall. It sounds odd. Thats what the kids dig smile.gif


QUOTE (Phil66 @ Jan 1 2022, 03:32 PM) *
Very interesting, thanks for sharing. I think he could have used a better track for the demo in the video though, it sounds weird to me, like someone is slowing down the turntable intermittently.

This could be helpful for some too https://www.gearnews.com/improve-your-produ...s-and-channels/

Cheers

You are at GuitarMasterClass.net


Don't miss today's free lick. Plus all our lessons are packed with free content!

Don't miss today's free blues, jazz & country licks. Plus all our lessons are packed with free content!
Go to the top of the page
 
+Quote Post

Reply to this topicStart new topic
1 User(s) are reading this topic (1 Guests and 0 Anonymous Users)
0 Members:

 




RSS Lo-Fi Version Time is now: 28th March 2024 - 03:16 PM