Ibanez Edge Iii Question |
|
Ibanez Edge Iii Question |
|
|
|
|
Nov 17 2007, 06:55 AM |
It should look like this:
-------------------- "It isn't how many years you have been playing, it's how many hours." -- Prashant Aswani "PRACTICE, PRACTICE, PRACTICE!" -- Michael Angelo Batio Check out my video lessons and instructor board! |
|
|
||
|
|
|
Nov 17 2007, 06:59 AM |
I believe you should make a line with body horizontally,in 2 ways.
First one shall be line between bridge and the body from player's point of view which can be adjustment by spins. Second one is from the rare look,where the fine tuners are. This can be done by setting all spins to almost same tension. Hope this helps a bit and sorry for lacking in my vocabulary. -------------------- Youtube
MySpace Website Album "Let It Out" on iTunes and CD Baby Check out my video lessons and instructor board! The Pianist tune is progress,check it out! "ok.. it is great.. :P have you myspace? Can i to personalize this for you guy?" |
|
|
||
|
|
|
Nov 17 2007, 08:36 AM |
The bridge should be paralled with the body. just like in the picture.
|
|
|
||
|
|
|
Nov 17 2007, 12:20 PM
|
|
omg
i was thinking about buying this guitar for my new one.. you think it's worth to buy ?? |
|
||
|
|
|
Nov 17 2007, 01:21 PM |
Read my review on my RG350MDX, exact same guitar, just different finish
|
|
|
||
|
|
|
Nov 17 2007, 03:29 PM |
Here. A picture or two helps. This is an EDGE III which is different. Here is the manual diagram: Here is they way I currently have it. You can forget aligning it parallel with the "door stop" or "pie sideways" bottom piece, because that is wrong. That's where I screwed up. I think the line should look just like the picture in the manual. There is a flat spot just to the left of the fine adjuster (no hump) and then it looks like the line goes straight through the center of the circular locking bolt for the low E. I believe I am forward just a bit. Need to reduce spring tension just a hair. ???? The Edge III has an angled baseplate it seems i.e. the top part is angled in relation to the bottom... Check out this page for some good tech advice: http://www.ibanezrules.com/tech/setup/index.htm |
|
|
||
|
|
|
Nov 18 2007, 08:24 AM |
omg i was thinking about buying this guitar for my new one.. you think it's worth to buy ?? Do some research. So far I hate this thing. |
|
|
||