Ibanez Edge Iii Question |
|
Ibanez Edge Iii Question |
|
|
|
|
Nov 17 2007, 03:29 PM |
Here. A picture or two helps. This is an EDGE III which is different. Here is the manual diagram: Here is they way I currently have it. You can forget aligning it parallel with the "door stop" or "pie sideways" bottom piece, because that is wrong. That's where I screwed up. I think the line should look just like the picture in the manual. There is a flat spot just to the left of the fine adjuster (no hump) and then it looks like the line goes straight through the center of the circular locking bolt for the low E. I believe I am forward just a bit. Need to reduce spring tension just a hair. ???? The Edge III has an angled baseplate it seems i.e. the top part is angled in relation to the bottom... Check out this page for some good tech advice: http://www.ibanezrules.com/tech/setup/index.htm |
|
|
||